Sorry, Douglas, you have it wrong. Look at
http://www.ttalk.info/picture_this.htm and scroll down to the Bonnet
Hinge Supports item. The rubber should be one continuous piece under
both bonnet supports.
Bud Krueger
admin@ttalk.info
Douglas Ormrod wrote:
>As you can see I have now made it to the front of the car in the
>reassembly process and have a couple of questions re the rubber strips
>that the hood sits on.
>
>The lacing that weaves its way round the radiator shell is in two parts
>and comes out the last hole on the top an inch or so from the centre of
>the shell. Question one is do I just glue it in place before it gets to
>the indent that the little chrome support for top hood hinge sits in, or
>tuck it underneath said hinge support and pass the bolts through the
>rubber? Or perhaps sandwich it between the inner and outer hinge
>supports?
>
>Similarly at the rear there is a rubber strip that is tacked to the
>wooden firewall strip which has another little chrome support that the
>top hood hinge strip sits in. Do I screw the hinge support through the
>rubber - or fix it straight to the wood and stop the rubber at either
>side? Or perhaps cut a bit out of the rubber but leave the outer bead
>continuous?
>
>Thanks
>
>Douglas
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|