In a message dated 9/5/2004 8:45:26 PM Pacific Standard Time,
Krislynco.llc@adelphia.net writes:
> Well the tf project is going great except I have a leak of tranny fluid at
> the
> very rear. I've removed the cotter pin and the castle nut and washer but
> cant
> seem to get the seal out...do i have to split the tranny in half or is there
> a
> trick to getting the seal out the back end over the spline shaft.. it's
> really
> recessed way in there...
>
I seem to remember that it is easy to have the flange butt up against the
seal and not go home as it should..........perhaps others will have the details
on this.
Terry in Oakland
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|