Nels,
I have "fixed" several T Type hinges over time by boring out the existing
hinge pin holes and making new pins. I admit that I have some machine tools
that makes the job easier but it isn't a difficult project as the brass is
quite soft. I have used Grade 8 bolts as a source for pin material.
Cheers, "Bob".
Colorado Springs, where it actually rained today!
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|