In a message dated 11/10/03 09:37:26 Pacific Standard Time,
duvallcom@sbcglobal.net writes:
<< Over the years of adjusting the lever, it
basically became too flat. Hold the the lid of the float chamber up and
let the float dangle then observe the needle to see if it stays
straight as you move the float up and down. It solved my similiar
problem on both my A and TD. >>
Some float levers have a little tab on the pivot end that you can bend to
prevent this hang up.....It took me years before I noticed it.
Terry in Oakland
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|