> If you mean the crankshaft pulley bolt, its 12 x 1.5 mm.
>
Ummmmmmmmmmm Topical!
I'm looking into a sad mess at the front of a TA engine where the
equivalent thread should be! - Anyone know if this is the same
thread as on a TC - or if not what it should be?
Regards
Clive
===========================
----- Original Message -----
From: "J.E.A.Rich" <mmmbob@adelphia.net>
To: "Richard Taylor" <rgt3000@fuse.net>; <mg-t@autox.team.net>
Sent: Saturday, November 08, 2003 6:20 PM
Subject: Re: T Series Engine
> Rick,
>
> If you mean the crankshaft pulley bolt, its 12 x 1.5 mm.
>
> Cheers, "Bob".
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|