>From memory, the lower bracket mounts on the breather pipe very close to the
bottom end of said breather pipe and bolts to the bell housing by means of
the nearest suitable bell housing to block bolt.
Jon Hermance, 53ish TD, 54ish TF1250
-----Original Message-----
From: Bud Krueger [mailto:budkrueger@earthlink.net]
Sent: Tuesday, June 18, 2002 5:48 AM
To: mg-t
Subject: Lower breather pipe bracket
Getting close to reinstalling the TD's engine after a whole lot of work.
Discovered that the odd shaped piece that I've had in my parts bin is the
bracket for the lower end of the breather pipe. For the life of me I can not
figure out where it would mount. Can anybody out there shed some light on
this?
Or, will it be obvious once I try to install it?
BTW, the engine rebuild has been a very interesting, enlightening
experience.
I'll write it up after I have it back in and running. Maybe next week.
Bud Krueger
52TD
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|