Re: Dropping in the Dizzy

[Bullwinkle <yd3@nvc.net>]

Scott:

Which clamping system does the block use for the distributor?  If it's
the later type, then the bolt which clamps it may have rotated so it's
half moon cut out will no longer let the distributor's shaft pass by. 
Also it is sometimes necessary to twist the distributor shaft some to
get the teeth of the gears to line up.

Blake

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-t