The rounded section of the rubber overlaps the scuttle (cowl) with the flat
section fastened to the support timbers. In other words when the bonnet is
in place, the flat sction is covered by the rear edge of the bonnet, and the
rounded section overlaps the body. The rear edge (rounded section) is the
only part that shows - and it DOES show.
Regards,
Lew Palmer
-----Original Message-----
From: BJCJ1@aol.com [mailto:BJCJ1@aol.com]
Sent: Saturday, June 26, 1999 4:27 PM
To: mg-t@autox.team.net
Subject: TF Dash
I am installing the rubber (Moss Part 280-250) which is for the Cowl to
Hood.
But when I took the rubber off to do the restoration, I forgot if the
rubber
bead goes over the dash and then nail the flat spot to the Top Rail and
Front
side Rails. Or if the rubber bead is placed on the Rails and butted up to
the dash top.
Thanks
Bob
Freehold, NJ
|