Don,
Here you go on the foot rest.
Cheers,
Lew
-----Original Message-----
From: owner-mg-mmm@Autox.Team.Net [mailto:owner-mg-mmm@Autox.Team.Net] On
Behalf Of Bob Grunau
Sent: Thursday, August 21, 2008 2:59 PM
To: TOM METCALF; DB35PA@aol.com; mg-mmm@autox.team.net
Subject: RE: 2 P-type questions
Don,
I agree with Tom, the needle may be "off".
I just got a TC tacko that read 5500 sitting still. Removed the needle, set
it at approx zero, and the tacko now reads accurately at 2400 RPM when I use
my 1200 rpm drill to drive it counter-clockwise ( tacko is 2/1 faster than
input cable ) .
Bob Grunau
On the tach, you may need to remove the cable, stick a small screwdriver in
the slot and dial it backwards. The pointer generally snaps right back to
zero. If not, you have a problem. The pointer could actually be "off", too.
tommmmmmmmmmmm
> 2. With engine off, my tach reads 600 revs. I don't see anything on the
> back
> of the tach that would allow me to "zero" it. Tach cable seems free of
> any
> binding or wiggles. Any suggestions besides either "live with it.. or
> remove
> it and ship it to someone else"?
>
> thanks,
> Don B.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
[demime 1.01d removed an attachment of type application/msword which had a name
of PtypeFootplate (3).doc]
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
|