mg-mmm
[Top] [All Lists]

Re: head to sump drain pipes

To: <TATERRY@aol.com>, <mg-mmm@autox.team.net>
Subject: Re: head to sump drain pipes
From: "Tom Metcalf" <mgtom@zoominternet.net>
Date: Wed, 30 Aug 2006 21:00:54 -0400
References: <bf2.2d44370.322779ec@aol.com>
Reply-to: "Tom Metcalf" <mgtom@zoominternet.net>
Sender: owner-mg-mmm@autox.team.net
Buy a new copper tube from Barry Foster. You can even use your original brass ends and silver solder it all together.


----- Original Message ----- From: <TATERRY@aol.com>
To: <mg-mmm@autox.team.net>
Sent: Wednesday, August 30, 2006 7:31 PM
Subject: head to sump drain pipes


Dues to an unfortunate accident yesterday, I bent the rear of head to sump
drain pipe. I have now lost the shape of it. I will try annealing it to see if
I can get it soft enough to regain the shape but I am also thinking of
cutting it off both ends and then connecting the two ends with rubber hose....OP
please avert your eyes!! This would make putting the head on and off a lot
easier also.

comments?
Terry

/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/cgi-bin/majorcool
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-mmm
///  Send list postings to mg-mmm@autox.team.net


<Prev in Thread] Current Thread [Next in Thread>