| To: | "viv@trax.co.za" <viv@trax.co.za>, mg-mmm@autox.team.net |
|---|---|
| Subject: | RE: Rivets |
| From: | "Jack Hardy" <jnshardy@earthlink.net> |
| Date: | Wed, 16 Nov 2005 17:47:39 -0800 |
| Domainkey-signature: | a=rsa-sha1; q=dns; c=nofws; s=dk20050327; d=earthlink.net; b=fBY9v7+vHyhr5whx3Ks6nDbS4UyOK5vDeeMC/1JfNJUTkgYkr864arJjQYMj7jtq; h=Received:Message-ID:X-Priority:Reply-To:X-Mailer:From:To:Subject:Date:MIME-Version:Content-Type:X-ELNK-Trace:X-Originating-IP; |
| Reply-to: | "Jack Hardy" <jnshardy@earthlink.net> |
| Sender: | owner-mg-mmm@autox.team.net |
Viv-All, I was unable to find rivets with the same low profile heads as original, so I got some flatheads with the same head diameter as the ones I took out and countersunk the plywood to accommodate the deeper heads. I got them at one of the large "chain" hardware stores (OSH) they were black Iron and easily peened on the inside. I added a flat washer over the rivet before peening it give a little more surface area. Jack Hardy PA1875 California, USA /// unsubscribe/change address requests to majordomo@autox.team.net or try /// http://www.team.net/cgi-bin/majorcool /// http://www.team.net/mailman/listinfo /// Archives at http://www.team.net/archive/mg-mmm /// Send list postings to mg-mmm@autox.team.net |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: exterior piping questions-PA, Tom Metcalf |
|---|---|
| Next by Date: | thanks, DB35PA |
| Previous by Thread: | Test, Wagner-Neu-Anspach |
| Next by Thread: | RE: Rivets, viv |
| Indexes: | [Date] [Thread] [Top] [All Lists] |