To: | "MG-MMM" <mg-mmm@autox.team.net> |
---|---|
Subject: | Roll-over protection for a P-Type |
From: | "Chris Bucknell" <c.bucknell@bigpond.com> |
Date: | Mon, 14 Feb 2005 04:40:11 +1030 |
References: | <BAYC1-PASMTP020E60609AEF86E0E3523D92680@cez.ice> |
Reply-to: | "Chris Bucknell" <c.bucknell@bigpond.com> |
Sender: | owner-mg-mmm@autox.team.net |
Hi All, I am at the very preliminary stages of investigating putting roll-over protection on our P Type 2 seater. Ideally I would like this to be fully removable with minimum modification to originality being detected once removed. So any one out there who has done this, has drawings, photos etc would be appreciated. Kind regards, Chris Bucknell Australia P-Type R-Type /// unsubscribe/change address requests to majordomo@autox.team.net or try /// http://www.team.net/cgi-bin/majorcool /// http://www.team.net/mailman/listinfo /// Archives at http://www.team.net/archive/mg-mmm /// Send list postings to mg-mmm@autox.team.net |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | PA Exhaust; Oil leak, Daniel Shockey |
---|---|
Next by Date: | J-5, TATERRY |
Previous by Thread: | RE: PA gearbox mount rubber bushings in the clutch bell housing., Bob Grunau |
Next by Thread: | RE: PA gearbox mount rubber bushings in the clutch bellhousing., Jack Hardy |
Indexes: | [Date] [Thread] [Top] [All Lists] |