Hi Experts,
Does anyone have close-up pictures of how rear quarter panel metal is shaped
around the top of the door post on a 34-35 PA? Would it be the same on Js or
early Ts as well?
There is a half round step in top of rear door post ... just above top hinge
inset. I can't figure out how to cut the metal to get proper fit for this
entire area.
Am I correct in assuming metal is removed from hinge inset ... rather than
shaped to conform to shape of hinge so hinge actually rests against wood frame?
Thanks,
Don B.
PA 1823
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|