Don,
Some of my radiator parts are scattered about, so I don't have many details
handy. But, the horn lugs on the headlight support brackets are to the
front. And, yes, the brackets are painted body color.
As I recall, the cross brace is screwed to the end (L shaped) brackets that
go through the rad shell). Mine are countersunk indicating that it may have
used a countersunk screw (1/4" BSF), not a bolt and nut.
If you figure all of this out, please take pictures as I guess I'll have to
figure it out too.
Cheers,
Lew
-----Original Message-----
From: owner-mg-mmm@autox.team.net [mailto:owner-mg-mmm@autox.team.net] On
Behalf Of DB35PA@aol.com
Sent: Tuesday, March 09, 2004 3:32 PM
To: mg-mmm@autox.team.net
Subject: PA rad mounting
Hi Fellows,
Seems I've wandered into one of those Chinese finger traps. The harder you
pull....
When offering up rad crossbar to end brackets (through the chrome shell),
I'm
stumped.
I note end brackets are threaded ... which leads me to try passing a bolt
through crossbar ... then thread on the bracket. However, nut head strikes
rad
side and no room to tighten. What's the tip?
Also, which way 'round for the headlamp brackets? They have an "ear" for
horn
assembly and? Does "ear" goes towards front or rear of car and painted body
color?
Thanks,
Don B.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|