mg-mmm
[Top] [All Lists]

Re: Oil Fitting

To: "Kevin Allocca" <kevin-allocca@msn.com>, <mg-mmm@autox.team.net>
Subject: Re: Oil Fitting
From: "Bill Tantau" <bill707@earthlink.net>
Date: Wed, 28 Jan 2004 19:36:49 -0800
References: <BAY4-DAV42cDbD4K1kC0005e0f3@hotmail.com>
Reply-to: "Bill Tantau" <bill707@earthlink.net>
Sender: owner-mg-mmm@autox.team.net
----- Original Message ----- 
From: "Kevin Allocca" <kevin-allocca@msn.com


> Need to oil my PA. I have been told 90wt-150wt oil is fine? Any thoughts
on
> what to use and where can I get an oil gun or fitting to match up to the
> nipple on the fire wall?
> Thanks from snowed in Richmond, VA
> Kevin
> PA1388

I successfully use a pointed needle-type oil gun fitting. It goes right in
the little hole to do the job.
Bill Tantau

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/cgi-bin/majorcool
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-mmm
///  Send list postings to mg-mmm@autox.team.net


<Prev in Thread] Current Thread [Next in Thread>