Terry,
Your questions are not "dumb", what surprises me the most is the small
number of respondents who are prepared to share their replies with the rest
of us.
My alignment "spear" is still available if you wish to borrow it.
Why the desire to glue everything together? We had nothing in the early
1930's except grease.
Cheers, "Bob".
> From: TATERRY@aol.com
> Reply-To: TATERRY@aol.com
> Date: Mon, 23 Dec 2002 23:44:18 EST
> To: mg-mmm@autox.team.net
> Subject: More Head Studs and other stuff
>
> Gents, none of you told me how much fun I was going to have fitting new head
> studs to a N type block.....Whew! I'll bet I had that head on and off a
> dozen times until I got the two rear most studs so that they didn't foul the
> cam pedestal and still left enough thread for the nut.
> A few other tight spots also up and down the camshaft.......
>
> Now that I have the head torqued down with a modified crow foot.....getting
> the dynamo into position is a trick. Made worse no doubt by my extremely
> shaved head......but I can just do it. Will be a pain if I have to do it
> after the engine is in the chassis.
>
> What's the consensus on gasket goo on the inlet and exhaust gaskets??
>
> and why am I the only one asking dumb questions on this list?? Thanks to all
> who respond.
>
> Happy Holidays to all!!!
> Terry
> NA 0613
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|