Hi All
Just heard from the machine shop again....different tune. The pistons that
are currently in the engine measure 2.359", slightly under 60 mm. Does this
mean that these are PB pistons? What is the difference between the PA & PB
blocks? Can I safely bore out to 20 over? Are 20 over pistons available?
Thanks,
Dennis
PA1518
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|