----- Original Message -----
From: Daniel Shockey <magnut_dan@hotmail.com>
To: <mg-mmm@autox.team.net>
Sent: Tuesday, June 25, 2002 3:44 AM
Subject: PA Engine Bolt Threads, Etc.
> Hello, Fellow MMM's,
>
> I am in the midst of rebuilding my PA engine. I had a rod bolt break
(going
> 60mph on the freeway), putting the rod through its cylinder wall. I am
> getting the block welded and probably sleeved.
>
> Today I removed the 'sludge' plugs from the crank. The books say to cut
> threads onto some Al stock and replace them. Can anyone tell me what
threads
> these are?
The thread is BSP (British standard pipe thread). These plugs are available
at any plumbing shop in the UK. If you can't get them in the US I can send
you some.
Graham Whitaker
(PA, SA, various Wolseley's, Morris Minor)
_________________________________________________________________
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|