Stefaan, Rather than using brass for bushing carbs, consider using bush
made from teflon. Used to do this on racing carbs, better seal, smoother
action, lasts forever with no wear on std. dia. shafts. Easier to work than
the brass in getting fit just right. Dick Duncan
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|