To: | "'Jack and Sherri Hardy'" <jnshardy@earthlink.net>, "'MG-MMM'" <MG-MMM@autox.team.net> |
---|---|
Subject: | RE: Dynamo drive gear clearance |
From: | "Lew Palmer" <lpalmer@mn.mediaone.net> |
Date: | Fri, 8 Feb 2002 16:23:00 -0600 |
In-reply-to: | <3C643103.2DF8186E@earthlink.net> |
Reply-to: | "Lew Palmer" <lpalmer@mn.mediaone.net> |
Sender: | owner-mg-mmm@autox.team.net |
is it important to shim the dynamo for the required clearance with the clutch pedal depressed? ======== Jack, Not as long as there is not so little clearance that the gears bind. Also, make sure that there is not so much clearance as to cause a lot of backlash and noise. Regards, Lew Palmer /// unsubscribe/change address requests to majordomo@autox.team.net or try /// http://www.team.net/cgi-bin/majorcool /// http://www.team.net/mailman/listinfo /// Archives at http://www.team.net/archive/mg-mmm /// Send list postings to mg-mmm@autox.team.net |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | RE: M-Type Bonnet Catches, Lew Palmer |
---|---|
Next by Date: | Re: Dynamo drive gear clearance, Bob Rich |
Previous by Thread: | Dynamo drive gear clearance, Jack and Sherri Hardy |
Next by Thread: | Re: Dynamo drive gear clearance, Bob Rich |
Indexes: | [Date] [Thread] [Top] [All Lists] |