>How about the hardware for mounting the side screens
to the door?
NO, except the hexagonal s/s sockets on door top are the same.
>How about the seat rake adjustment pieces?
NO, although similar idea.
>Front stub axles
NO, TABC is larger although similar design. Kingpin bore is 3/4" on TC, 5/8"
on P.
> and bearings?
YES!!! Modern sealed bearings are tits.
>Windscreen hardware
NO, TABC uses BSC (26tpi all diameters). The mounting mach screws may be
used from TC. On original Ps I've seen, the mounting screws are 1/4"d,
slotted, of course, and 4 were used. The center mounting hole on both sides
used a wood screw. Polished stainless works best.
Also, the wedgie washer is same as TC.
>and rubber parts?
YES!!! All w'screen rubber is interchangeable. Fuel tank rubber straps and
mounting rubber same as TC, too.
> Thanks,
>
> Don B
>
> /// unsubscribe/change address requests to majordomo@autox.team.net or
try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/mg-mmm
> /// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|