land-speed
[Top] [All Lists]

Re: [Land-speed] Accident Data Acquisition

To: "Elon" <saltfever@comcast.net>, "land-speed submit"
Subject: Re: [Land-speed] Accident Data Acquisition
From: "Benn" <karhu@california.com>
Date: Thu, 11 Sep 2008 15:02:39 -0700
Sounds good--who's designing it?  The concept sounds good, and lots of
accident investigators would use such a device, I think.
I've witnessed lots of instrumented crashes, and the closest I've seen to
what you're describing utilized an Edelbrock (I think) data acquisition
system.....way bigger than a matchbox.   And I'm not sure it had the 1000 hz
x 6 channels sampling rate you'd probably want (x, y, z, pitch, roll, yaw).
Benn


----- Original Message ----- 
From: "Elon" <saltfever@comcast.net>
To: "land-speed submit" <land-speed@autox.team.net>
Sent: Thursday, September 11, 2008 2:39 PM
Subject: [Land-speed] Accident Data Acquisition


>I posted the following on landracing.com however, I don't see any of the
> regulars on this list commenting.  My posting was in response to all the
> recent comments on this LSR list about the Hans device. I thought posting
> to
> landracing.com would be exposure to a larger audience with the
> corresponding
> larger feedback. However, and surprisingly, only 3 bike racers replied. So
> I
> am re-posting my comments here.
>
>
>
> "I think there is more or less agreement that collecting the best
> engineering data from an accident helps everybody. SCTA already does
> accident analysis that is not shared. And that information may or may not
> result in changes or additions to rule book safety regulations. So the
> question is; who should be responsible for accident Data Acquisition
> System
> (DAQ) if the information is never shared.
>
> The high cost of safety equipment has already been mentioned and a black
> box
> would be too costly a requirement for every racer. However, SCTA could
> create their own DAQ.  It could be installed into each car on the starting
> line and removed at a collecting point on the return road to be brought
> back
> to the line. It would not take many units to keep up with the flow of
> traffic. A simple, flat plate mounting base would cost the racer nothing
> to
> add to his cage.  With clever design the DAQ could be held in with locking
> DeStaco clamps or over-center devices.  Design intent would be an
> installation in 10-15 seconds. It would have its own self contained
> battery
> power (charged at night) and a SD or CF card. The card would be removed
> after an accident".
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> Land-speed mailing list
>
> You are subscribed as karhu@california.com
>
> http://autox.team.net/mailman/listinfo/land-speed
_______________________________________________
Support Team.Net  http://www.team.net/donate.html

Land-speed mailing list


http://autox.team.net/mailman/listinfo/land-speed

<Prev in Thread] Current Thread [Next in Thread>