land-speed
[Top] [All Lists]

Re: [Land-speed] Electric water pumps

To: <neil@dbelltech.com>, "'Tom Bryant'" <saltracer@awwwsome.com>,
Subject: Re: [Land-speed] Electric water pumps
From: "Ed Weldon" <23.weldon@comcast.net>
Date: Thu, 14 Feb 2008 17:16:06 -0800
Always an interesting subject.  I'd like to stick my fingers in here to ask if
anyone has some actual up to date data for modern engines on the heat loss to
coolant.  If you've messed around with engines on dynos a lot maybe you can
lend some insight.
The data I have is from a chart in the 1944 edition of Obert and Jennings,
Internal Combustion Engines, Analysis and Practice.  Test engine was an 8
cylinder flathead somewhere around 280 cubic inches and 5.4:1 compression
ratio.  Heat lost to "coolant", which included water as well as  radiation and
conduction from hot external surfaces ranged from 9.4% at 1000 rpm to 8.7% at
3600 rpm.  Percentages are related to the total BTU content of the fuel
consumed.  Kind of hard to extrapolate this to your "run of the mill" 600hp
small block.
Any good data points out there?
Ed Weldon

----- Original Message -----
From: <neil@dbelltech.com>
To: "'Tom Bryant'" <saltracer@awwwsome.com>; "'LAND SPEED LIST'"
<land-speed@autox.team.net>; "'Adin David'" <DavidAdin@mercydurango.org>
Sent: Thursday, February 14, 2008 4:22 PM
Subject: Re: [Land-speed] Electric water pumps
_______________________________________________
Support Team.Net  http://www.team.net/donate.html

Land-speed mailing list


http://autox.team.net/mailman/listinfo/land-speed

<Prev in Thread] Current Thread [Next in Thread>