In a message dated 9/24/2007 6:16:42 PM Pacific Standard Time,
lsr_man@yahoo.com writes:
> I want to install a warning light for low oil pressure (under 30 lbs); and
> a warning light for too hot (245 degrees?). Does anybody have the part
> numbers for such switches from either NAPA, Speedway, Summit or GM? Going on
>a
> BBC.
>
> DickJ
>
Moroso makes a kit for the oil pressure #49500
A poormans way to do it if you can't watch the guage for water temp is to put
tape over the gauge where you want it to run below (if you want it to run @
200 put the tape there). If you glance at the guage and the needle is "gone"
shut it down.
**************************************
See what's new at
http://www.aol.com
_______________________________________________
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|