John. It will look like a bar that is running out a lot. The cut will start
on the high side and work it's way around until it's round. Only the center
of the bar, and it's diameter will change. It's similar to starting off with
a forged piece of stock. It's not round to start with and the machinist part
comes in moving it around to where you get it round before going undersize.
RF
----- Original Message -----
From: "John Burk" <joyseydevil@comcast.net>
To: "land-speed" <land-speed@autox.team.net>
Sent: Friday, June 02, 2006 8:03 AM
Subject: Taper question ( lathe stuff.. could be LSR )
> Elon
> Wouldn't the tailstock end of an off-set center cut look like ( ).
> John Burk joyseydevil@comcast.net
|