What's the big deal. I cut tapers all the time. What I want to know is how
do you cut a straight diameter? RF
----- Original Message -----
From: "Larry McAfee" <lgmcafee@mchsi.com>
To: "land speed" <land-speed@autox.team.net>
Sent: Monday, May 29, 2006 4:02 PM
Subject: Taper question
> What Don Thigpen told you to do is the correct way to cut a taper without
> a
> taper attachment. But if this taper doesn't need to be that close you can
> set
> your compound and cut a taper as far as your compound will let you then
> back
> it up and move your carriage and pick it up again and do the same thing
> until
> you have it the length you need than blend it in with a file and emory
> cloth
> and you are set to go.
> Larry Mac
|