drmayf wrote:
> Yeah, yeah, yeah.... I know you are tired of me asking about dzus
> fasteners. Well, I have then mostly in hand and about 2/3 of them
> in. BUT, and that is a BIG but, the panel dimpler I have is for the
> non-self eject kind. The self eject have the metal seat attached with
> the ejecting spring. This requires that the dimple be much larger that
> th enon eject kind. What's a mother to do? Just for chuckles I toyed
> with the dremel to see if I could open the dimple that way...wont live
> long enough to get r done that way. Is there a larger panel dimpler
> for these self eject fasteners? And yes, it is looking pretty good
> right now...One more panel and fixing these dimples and I am
> done...once again...
>
> lemme hear from ya'll about what to do with the dimpler issue..
> Mayf,
If there is a tool, I have not found it. I made one but I usually punch
the hole bigger so it doesn't require a flare saving myself a step. If
your putting the top panel on top of another panel, just use a counter
sink tool, use a single cut and go slowly until it clears.
Hope this helps.
joe
|