RE: GM 3 Bar MAP Sensor

["Dave Dahlgren" <ddahlgren@snet.net>]

5 volts it is..
Dave

> -----Original Message-----
> From: owner-land-speed@autox.team.net
> [mailto:owner-land-speed@autox.team.net]On Behalf Of drmayf
> Sent: Monday, August 29, 2005 7:42 PM
> To: LSR
> Subject: GM 3 Bar MAP Sensor
> 
> 
> Does anyone have any particulars regarding the use of a GM MAP sensor (2 
> or 3 bar) as a boost pressure measuring device? I have a 5 volt 
> reference signal available and can log 0 to 5 volts (more if I use a 
> resistor dividing circuit). What does the MAP sensor need? I see power, 
> ground and signal return: what volts does it need?
> 
> mayf