I guess I would use an end mill. Rich Fox
----- Original Message -----
From: "Bryan Savage" <b.a.savage@earthlink.net>
To: "atrav" <atrav@copper.net>
Cc: "LSR list" <land-speed@autox.team.net>
Sent: Sunday, May 22, 2005 02:10 PM
Subject: Re: Brake pad material removal
> Aron,
> I would use a small sanding disk in my drill press.
> Bryan
>
>
> atrav wrote:
>
> > With one of my projects I've mixed and matched a different caliper to a
different make brake rotor.
> > Fits
> > fine except with a new rotor and new brake pads they are tight. Not
locked, but rubbing far too
> > much.
> >
> > I need to remove about a 1/16" of brake pad material from each pad,
what's a good way to do that?
> >
> > TIA,
> > -Aron-
|