I always thought there are good welder operators and some that are not.
seems like a lot of things were made before a tig welder was invented.. I am
willing to bet there are a lot of stick welders that can put a typical tig
operator to shame especially the hobbyist type like most of us. I bought a
tig welder so I could tack things and smarter people could weld them until I
happen to either get very good at it or it is silly bracket for something
around the shop that hot glue would have been enough. I have done a lot of
engineering for rods and gas for my products but don't claim to know more
than what I remembered from reading. i think i will stay away from politics,
religion and lubrication ..
Dave
-----Original Message-----
From: Nt788@aol.com [mailto:Nt788@aol.com]
Sent: Tuesday, December 21, 2004 2:08 PM
To: Nt788@aol.com; kturk@ala.net; edvs@yahoo.com; James.Tone@AES.com;
ddahlgren@snet.net; land-speed@Autox.Team.Net
Subject: Re: Whatever did we do before Mig welders?
In a message dated 12/21/2004 2:38:47 AM Pacific Standard Time,
Nt788@aol.com writes:
>but like I said.... unless I was
>doing farm equipment I'll stick to the Mig or Tig.... both are far
better
>anwers... and somewhat easier......
Seems like welding is like religion, politics and oil! jack
|