This was very interesting--thanks. I hadn't considered using liquid nitrogen
for shrinking press-fit parts for easy installation before but I should
have; I used to use it all the time.
Regards, Neil Tucson, AZ
-----Original Message-----
From: owner-land-speed@autox.team.net
[mailto:owner-land-speed@autox.team.net] On Behalf Of atrav
Sent: Tuesday, November 25, 2003 8:30 PM
To: LSR list
Subject: Fw: Aluminum Engines
----- Original Message -----
> VERY interesting info on aluminum bocks, including liners, bore prep, etc.
>
> http://www.msi-motor-service.com/download/broschueren/alu_en.pdf
|