Dick
Fix it your self, the stud should drive out without to much trouble. If you
pull the axle you need to raplace the seal and gasket.
Glen
----- Original Message -----
From: "Dick J" <lsr_man@yahoo.com>
To: <land-speed@autox.team.net>
Sent: Friday, July 11, 2003 1:37 PM
Subject: Mustang rear axle
> I need to replace a broken wheel stud on my daughter's 96 Mustang with
rear disc brakes. Has anybody done this? Is it so different than doing it
on a Chevy (Knock the old one out with a hammer, pull the new one in place
with an impact wrench, lug nut and spacer)? She was going to have the Ford
garage do it, and they wanted $80+ ???? I bought the parts for two bucks
this morning. I figure that even if I have to remove the caliper and pull
the axle I can do it for a lot less than $80!
>
> Dick J in East Texas
>
>
> ---------------------------------
> SBC Yahoo! DSL - Now only $29.95 per month!
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|