There's a big difference between an aluminium spanner and an aluminum
wrench. I'm not sure but I think only the former carries FIA approval.
Mat.
-----Original Message-----
From: Dave Dahlgren [mailto:ddahlgren@snet.net]
Sent: 02 May 2003 20:25
How would you think that we tighten an AN fitting.. Not with a pipe
wrench.. But
those are alloy around here as well..
Dave
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|