Mayf
Go to a tool rental place and rent a set of chassis punch's used by
electricans. They come in all sizes and make a neat clean cut in sheet
metal.
I think they are called greenlee punchs.
Glen
----- Original Message -----
From: "DrMayf" <drmayf@teknett.com>
To: <land-speed@autox.team.net>
Sent: Friday, March 14, 2003 4:32 PM
Subject: Tool Borrow?
> Ok, does anyone have any of those nifty stepped drills for putting holes
in
> sheet metal? The are variously called unibit, stepped bit, stepped
drill...I
> need to put some holes in my trunk firewall for feed throughs but those
> suckers cost a lot. I need to put about a 1/2 dozen holes in various
places
> ranging from 5/8 inch dia to what ever a 3/4 inch pipe diameter is.
Anybody
> have one/several to let me borrow? Beg? Steal?
>
> mayf
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|