Gentlemen,
I've got my drawings done and am trying to figure out how
to go about fairing the fiberglass body curves. I have
sections at various points, and I can cut patterns for
these points. The rub is getting the compound curves between
the stations. I've got access to a large plotter and could
plot waterlines and make templates. What I need is some
software that would take my cross sections and create a
3D skin that I can tweak, section, and plot. I'm not sure
I trust my eyeball to get the left side and the right side
the same, or to get the curve I want. Any affordable options?
Thanks,
Jim W.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|