I think it might be smaller as a H engine in a lakester gets you over 220 now...
:>)
Dave
Elon Ormsby wrote:
>
> Dave Dahlgren said . . . "Yikes with a typical 6" facing mill that is over
> 11k SFM.. Talk about going for it!! Sure hope he uses a lot of coolant when
> cutting!!
>
> That is a SFM of only 125 MPH. Must be an "H" motor milling
> machine :-) -Elon
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|