Mayf.
Try any source for Imperial - Eastman or Parker Hydraulics., The both make
them. I see them at the swap meets now and then as well.
Glen
----- Original Message -----
From: "DrMayf" <drmayf@teknett.com>
To: <land-speed@autox.team.net>
Sent: Tuesday, December 10, 2002 10:15 AM
Subject: Tubing Bender Question
> I can find lots of tube benders for small diameter aluminum, copper and
> steel tube. But, I have a need to bend some -8 and -10 size aluminum tube
> for my water plumbing. Anybody know of a source? I found a $54, 37 degree
> flaring tool so that part is taken care of.
>
> TIA,
> mayf
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|