After many years, I started the stock engine in my 47 Ford woodie. The
Holley 94 carb has a small leak between the castings. I replaced the
gaskets. I was thinking to sand the surfaces with 400 grit sand paper using
a flat block. Also was wondering if there is a sealer that might help in
this area. Any ideas would be appreciated. Terry Hunt, Guam Bomb, #743
_________________________________________________________________
Chat with friends online, try MSN Messenger: http://messenger.msn.com
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|