Bob, Do you have a press? You can make it into a press brake with a
couple of pieces of angle iron. Also you can make a brake with a couple
angle iron pieces, hindges, C clamps. About $20 and an hours work should
be it. Doug Odom in big ditch
BWANA343@aol.com wrote:
>
> REgarding sheet metal,does anybody have any special tricks for bending larger
> pieces of sheet metal ? I mean larger than with hand tools,but smaller than
> "brake" size sheets ?..........Bob,full of
> sheet,Wanner...................................................... .
> ..............................................................................
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
|