Kvach;
"Burned in with a torch?" sounds pretty crude. I'd weld up those holes and
drill a proper size hole if necessary. Some types of thermocouple probes
screw into a threaded bung but for only a temporary EGT measurement, a thin
probe (just two wires welded together at the tip) can be inserted into a
small hole in the headers.
Regards, Neil Tucson, AZ
-----Original Message-----
From: Salt Hawk [mailto:salthawk@coldreams.com]
Sent: Wednesday, November 28, 2001 2:21 PM
To: saltracer@awwwsome.com
Cc: Jonathan Amo; Finishline Coatings; land-speed@autox.team.net
Subject: Re: This is not an Advertisement
Well I guess I would have considered that except they appeared to be
about 1/8 " in diameter and burned in their with a torch instead of drilled,
don't most exhaust temp probes screw into the header? Kvach
///
/// land-speed@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe land-speed
///
/// or go to http://www.team.net/cgi-bin/majorcool
///
///
|