Dick, They are all thin wall castings. Anything over .030 is not going
to hold up very well. That only gives you 267 CID. Hard to get any valve
size into that small of a bore also. Doug Odom in big ditch
Dick J wrote:
>
> I've been sitting here making good use of my
> lunch hour looking at SBD dimensions and have
> come up with a question. The weakling of all
> SBCs had to be the 262 that was made during the
> mid-seventies. It has a b/s of 3.671 X 3.1.
> Could the 262 block be bored enough and keep the
> 3.1 crank be a good candidate to make a "D"
> motor?
///
/// land-speed@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe land-speed
///
///
|