DrMayf <drmayf@teknett.com>:
Tell us your sourse on the injector bungs--do they have
bungs for the fuel rails also--you all knowing,
inhabitant of western arid regions.wmts
> Well, now....you have had interesting discussions
with Brad, huh? So why
> not
> post the results of your discussions and let us be
illuminated! Except for
> me, I am always in the dark. I have the rod ratios
for just about most of
> the modern Ford engines on my web site.
http://wwwteknett.com/pwp/drmayf
> Thanks to all who assisted me on door fasteners. I
decided that you all
> were
> correct and I went back to the original door latches.
I managed to find all
> the hardware and now have the drivers door
temporarily installed. Nedd to
> adjust some hinges... and the striker. Also, for all
the Platense fans, I
> still have not found the definition. But it does not
matter anyway, because
> the land deal for the two 1 1/4 acre plots fell
through. Drat!! Off looking
> again. Oh, Ordered my driveshaft from Driveline
Service in Las Vegas. Pick
> up Monday. Also found a cheap place to get injector
bungs...40 bucks for 8,
> which is 20 bucks cheaper that just about everywhere
else. Also bought
> finished fuel rails good for about 1500 hp. So I'll
have a lot of margin.
> Cleaning parts...sigh... Oh, I added some stuff about
compression ratio and
> how to figure it then some thoughts on cylinder
pressure with boost. Same
> web site. Working on Coastdown right now. Still have
to do the model of NOS
> into a NA motor and how that flow system works, and
for Dick J add some
> additional info on power required for the
salt....'nuff to keep me busy....
>
> ciao
>
> mayf the ignorant desert rat
>
> ----- Original Message -----
> From: "Keith Turk" <kturk@ala.net>
> To: <land-speed@autox.team.net>
> Sent: Saturday, June 09, 2001 2:58 AM
> Subject: Bore/Storke relationship's
>
>
> > Okay ... I was sitting around waiting for some new
subjects....( actually
> I
> > have been buried in Cow Manuare)( nahhh I ain't
been by Rick's Place )
> >
> > What's are favorite Bore and Stroke relationship's
and why?
> >
> > or Who has some thoughts on Rod Ratio's? Brad and
I have had lots of
> > interesting discussions on them....
> >
> > K
>
> ///
> /// land-speed@autox.team.net mailing list
> /// To unsubscribe send a plain text message to
majordomo@autox.team.net
> /// with nothing in it but
> ///
> /// unsubscribe land-speed
> ///
> /// > ///
///
/// land-speed@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe land-speed
///
///
|