Thanks Larry,
I am the one who asked the question. I eventually found Race
Engineering by myself. Their tool is a little pricey, I think I will try
poking holes in my fingers a few times before I give up and buy one.
Jim in Palmdale
----- Original Message -----
From: <LGMCAFEE@aol.com>
To: <land-speed@autox.team.net>
Sent: Monday, June 04, 2001 7:32 PM
Subject: spirolock tool
> A while back someone wanted to know about a tool to remove the spirolock
clip
> in a piston. I was looking at the June issue of Car Craft and they had a
tool
> from Race Engineering called the lockbuster for this purpose. There phone
> number is 651-533-5500. Has any body used bearing spacers to put a smaller
> journal crank in a block and what kind of success did you have? Larry
Mac
///
/// land-speed@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe land-speed
///
///
|