Are there any suggestions about what to use on an open
deck aluminum block (MX-3) for a block filler?
Thanks, Bryan
PS: The Teledyne Continental IOL-200 in the Rutan Voyager
(rear engine) had water jacks only on the top 1/3 of the
cylindar.
Dave Dahlgren wrote:
>
> yes to all.. do it first make sure everything is very clean
> follow directions on temp etc to the letter.. and yes it
> works! Don't go too crazy with it though as the walls have
> to have some cooling..
> Dave Dahlgren
>
> LGMCAFEE@aol.com wrote:
> >
> > Has any body used the concrete type filler that they put in blocks to make
> > them more rigid. I know they use this a lot in drag racing but will this
>work
> > for the salt. I am going to bore a 283 out to 302 and thought I might fill
> > the block about 1/2 full.
> > If I do go this route should I fill before having it bored?
> > Thanks Larry Mac
|