Larry,
Why not just use a 350 4-bolt block and a chevy 3 inch stroke Z-28 crank. Check
with your local auto machine shops, you may find a good used crank laying
around.
There is a lot of small block stuff available.
Hey, Keith...don't you have a 3 inch stroke crank holding up your workbench?
Nsmcafee@aol.com wrote:
> Hi Group, I am trying to find out the best way (cheapest) to build a 302 ci
> Chevy motor. I know a 4 inch bore and a 3 inch stroke would give you 302 ci,
> but how is the best way to achive this? Do people bore out a 283 block to
> come up with this or do they use a 327 with a 4 inch bore and 283 crank with
> a 3 inch stroke? The problem with this motor is that it can only be bored
> .020 to stay under a 305 ci class. You would need a block with little wear
> to clean up at .020 which might be hard to find. If I would use a 350 ci
> block, I would need a custom ground crank. rods and pistons. I don't know if
> this is the way to go or not.
>
> I was looking at the Studebaker first, but I think I might be better off to
> go with the modified pickup class. The rules say 1949 and later. I know
> where a 1949 Chevy is. Would this work okay? I've looked at the rules for
> this class and I still have questions. Does a stock front axel have to be
> used or can a late model stub be used? Can a quick change be used? I'm
> getting a lot of good information off the email list and I would tell anybody
> like me trying to get started the archives at listquest.com is very
> informative. Thanks, Larry
|