My mistake on the seat slide thread size. Should be 1/4 -28tpi
I used my thread gauge on a rusty part which is always a bad idea.
Perry
Sent from my iPhone
> On Dec 31, 2020, at 3:47 PM, Bob Spidell <bspidell@comcast.net> wrote:
>
> Wow! Those slides are pretty nasty; was that car submerged for a couple
> decades? I probably would have sprung for new if they were that bad.
>
> Sorry about the bad info on the bolt size. I think it was wishful thinking;
> 5/16" wouldn't be so easily worn and/or stripped.
>
>
>
>> On 12/31/2020 11:21 AM, Perry Small via Healeys wrote:
>> Simon
>> Bobs info is pretty good. Bolts are 1/4-24 unf and they have a round flat
>> head. Originally resistance welded in place.
>> Second photo is where the pins that have to be removed are located.
>> There is a set of ball bearings that you should locate before taking the
>> slides apart. The ball bearings will probably be worn or rusted so find
>> suitable replacements and reinstall in the original locations. Need more
>> just ask.
>> Perry
>>
>>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/healeyguy@aol.com
>
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|