Yes open up the seam and extend the wire into the wing, so that it provides
a stiffer connection between the two pieces. New patch and old fender.
Ira Erbs
Portland,OR
_______ _______
(______ \____1959 BN4____/ _______)
(_________________________)
BT7 engine and disk brakes
1967 MGB [image: MG]
A racing car is an animal with a thousand adjustments. Mario Andretti
Please excuse random auto corrects and misspelled words
On Thu, Sep 28, 2017 at 11:03 AM, Mike Tobin <ahbt71 at gmail.com> wrote:
> Hi All,
> I've got my patch panels for the lower part of the four wings. They all
> have a few inches of the wheel well beading extending beyond the top of the
> patch. All the usual vendors' pictures show this. Is this extra that I
> just cut off? I would be good, I suppose, to have it replace the
> equivalent bit of beading in the original, but I don't see how I could get
> the old bead out without mucking up the wing.
> I went ahead on one dog leg and cut that piece off and the new piece
> welded on fine. Should I have done something else?
>
> Thanks Again,
> Mike Tobin, Townsend, MT
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/
> options/healeys/eyera3000 at gmail.com
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170928/beb55880/attachment.html>
|