Hi
I remembered wrong, I made it from a 55 mm hexagon socket.
Per
Skickat fr?n min iPhone
> 6 sep. 2017 kl. 08:52 skrev Per Schoerner <per at schoerner.se>:
>
> Mike
> Note that the nut is an octagon, would fit better on an MG. And one of them
> is threaded the other way around. I made my own socket from a very big
> hexagon socket (46mm IIRC) that I grinded to an octagon.
>
> Per
>
> Skickat fr?n min iPhone
>
>> 6 sep. 2017 kl. 00:01 skrev Michael MacLean <rrengineer.mike at att.net>:
>>
>> OK, figured out how to get bearing hub off rear axle with a bearing flange
>> and slide hammer. Is the hub nut 2 3/16ths? Is there a socket available
>> without the chamfer around the mouth of the socket so I can get it on that
>> thin nut? Do you guys just buy a 2 3/16ths socket and grind the mouth flat?
>> The nuts on my axle are all buggered up from someone in the past using a
>> chisel to get them off and put them back on.
>> Mike MacLean
>>
>>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/per at
> schoerner.se
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170906/bb23b96b/attachment.html>
|