Hello,
I am getting back to my Healey 3000 engine rebuild after two
years. I bought the Roller master vernier timing gear set from Moss at
that time. I have previously used the Roller Master gear set with
multiple key ways to adjust the cam timing with no problems on other
rebuilds. What I don't like about this set is that the cap screws used
to clamp the vernier gear to the hub are not very robust. Working in
aviation I have AN-4 bolts that I can replace the cap screws with and
safety wire them to prevent slippage. Has anyone using this kit had
problems? I could keep the cap screws and Loctite them. This is a
street car, not a race car. Pictures are one bolt installed and the
hardware side by side.
Wayne
-------------- next part --------------
A non-text attachment was scrubbed...
Name: IMG_2537.jpg
Type: image/jpeg
Size: 88085 bytes
Desc: not available
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170705/49746211/attachment.jpg>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: IMG_2540.jpg
Type: image/jpeg
Size: 56820 bytes
Desc: not available
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170705/49746211/attachment-0001.jpg>
|
