--===============3985625217117126401==
--001a1143ef623ed54a0522fa4251
Generator plate leaked after I last removed it. Cleaned Right Stuff off,
used copper gasket sealer. When removing old bolts i realized the one above
the leak spot was not fitting right. retightening bolts and replacing weird
one went well. I hand tightened all bolts until firm. One upper bolt would
not tighten and now it won't untighten either. Wanky one was a bottom bolt.
Any suggestions for removing bad bolt? and clean up the threads ? Shit I'd
just like to drive the bugger.
Mr. Ira Erbs
--001a1143ef623ed54a0522fa4251
Content-Transfer-Encoding: quoted-printable
<p dir=3D"ltr">Generator plate leaked after I last removed it. Cleaned Righ=
t Stuff off, used copper gasket sealer. When removing old bolts i realized =
the one above the leak spot was not fitting right. retightening bolts and r=
eplacing weird one went well. I hand tightened all bolts until firm. One up=
per bolt would not tighten and now it won't untighten either. Wanky one=
was a bottom bolt. Any suggestions for removing bad bolt? and clean up the=
threads ? Shit I'd just like to drive the bugger. </p>
<p dir=3D"ltr">Mr. Ira Erbs</p>
--001a1143ef623ed54a0522fa4251--
--===============3985625217117126401==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
--===============3985625217117126401==--
|